home
log in
manual
calculator
contact
not logged in
- Configuration not saved

Modem
monitor
- common
  - alarm
  - event
  - system
  - redundancy
- modulator
  - ACM
  - AUPC
  - drm
  - BOD
- demodulator
  - line
  - drm
  - direct aes
- interface
  - status-TX
  - status-RX
  - Gb ethernet
  - gigE
  - E3
  - tsoip
- network
modulator config
- line
- channel 1
- channel 2
- MGMT channel
- CID
- AUPC
- BOD
- OTA Sync
demodulator config
- line
- channel 1
- channel 2
- MGMT channel
- protection
- DiSeqc
  - define
  - execute
interfaces config
- ASI
  - TX-ASI-A
  - TX-ASI-B
  - RX-ASI-A
  - RX-ASI-B
- TEST
  - TX-test
  - RX-test
- GBE
  - Gb ethernet-A
  - Gb ethernet-B
- gigE
  - RJ45
  - SFP
- TSoIP
- E3
  - Physical
  - Pseudo Wire
network config
- forwarding mode
- interfaces
- remotes
- routing
  - routes
- switching
- QoS
- TCP Optimization
system config
- management
  - IP
  - Rate-Limiter
  - Rollback
  - SNMP
  - Alarms&Events
- redundancy
- 10Mhz clock
- serial port
- date&time
- drm
- direct aes
system
- database
- hw/sw versions

Demodulator Line status

Error occurred. Please try again later.

General
Mode	0	Symbol Rate	0
State	0	Symbol Rate Offset	0
Pilot-SNR	0	Roll Off	0
Composite Power	0	RF Frequency	0
Signal Power	0	Frequency Offset	0

Echo Cancellation
State	0	Satellite Delay	0
TX Frequency Offset	0	Gain Difference	0

Channel-1
Data Rate	0
Link Margin	0
Status	0
SNR	0
Modulation	0
FEC-Rate	0
Pilot	0
Frame-Size	0
Frames	0
Error Frames	0
FER	0

Channel-2
Data Rate	0
Link Margin	0
Status	0
SNR	0
Modulation	0
FEC-Rate	0
Pilot	0
Frame-Size	0
Frames	0
Error Frames	0
FER	0

PRBS
Source	0	Errors Bits	0
Data Bytes	0	BER	0

MODE CODE Table (limited to 60)
Modulation	FEC-rate	Pilot	Frame-size	Frames	Error-Frames	FER	Link-Margin	SNR	Designated-To-Unit?

Last cleared on 00/00/000 00:00